Installation Guidelines and Requirements

Note:  This equipment is not intended for mounting to the wall or ceiling at distances above 2 meters from the floor.

•Before installing the unit, read and follow the guidelines in the NCR SelfServ™ XK22 (2246) Site Preparation Guide (BCC5-0000-5390) and the NCR Workstation and Peripheral AC Wiring Guide (BST0–2115–53).

•Install the terminal near an electrical outlet that is easily accessible. Use the power cord as a power-disconnect device.

•Do not permit any object to rest on the power cord. Do not locate the terminal where the power cord can be walked on.

•Use a grounding strap or touch a grounded metal object to discharge any static electricity from your body before servicing the terminal.

•If the power cord is replaced, it must be replaced with the same type of cord with the protective shroud.

•Do not route the power cord through openings with sharp edges.

Caution:  Avoid touching the touchscreen glass during handling or installation of the kiosk.

Caution:  The units contains hazardous voltages and should only be serviced by qualified service personnel.